H2 Rotor Puller

Phil Ives

Hermosa Beach, CA

Tech tip: Since H2 magneto rotor pullers are not available, and I could not find a 10 x 1.25 x 110mm screw to fashion into a puller, I made one 1.25 x 35mm screw and a piece of 1/4" rod as follows:

Drill 1/4" hole approximately 3/16" into end of machine screw (salvaged from triple tree clamp or ?). Cut approximately 1-1/2" of 1/4" rod (or shank from 1/4" hardened bolt) and insert in tip of 10 x 1.215 machine screw. Now grease the threads and remove the rotor! Be sure to reinstall with anti-seize compound.